Machine tool and automation equipment guide screw installation skills
100% leverage, C-pliers, hex wrench
Guide screw
This page is taken from experience without authorization
Hold the guide close to the datum
Twist in the bolt, pay attention to each bolt in the guide rail mounting hole to leave a gap, in order to facilitate later adjustment
Use a torque wrench to gently secure the bolts without overtightening them.
Tighten the side positioning bolts so that the press block compacts the guide rail and eliminates the gap
After the two guides are installed as above, use a lever dial indicator to test the parallelism of the two guides.
The last step is to install the slider table. In the following steps, pull the table after installation to check whether the resistance is normal. 1. Gently install the workbench on the LM slider and slightly tighten the mounting bolts. 2. The reference side of the LM slider is close to the reference side of the workbench through the positioning bolt, so that the workbench is positioned. 3. Tighten the mounting bolts on the base side and the slave side. The sequence of bolt installation is shown in the figure on the left. Tightening the bolts in the diagonal sequence equalizes the fixing of the table. 4. High precision, or when the workbench is too long and the width is very wide, it is not installed in diagonal order, and is fixed in sequence from one side of the track, which can eliminate the installation stress and obtain higher precision. For more details, please refer to www.neda-tech.com